Papilio Pro Boards

http://papilio.cc/index.php?n=Papilio.PapilioOne

The Papilio is an Open Source FPGA development board based on the Xilinx Spartan 3E FPGA (datasheet). It has 48 I/O lines, dual channel USB, integrated JTAG programmer, 4 power supplies, and a power connector. It provides everything needed to start learning Digital Electronics.

 

Power

Four independent power rails at 5V, 3.3V, 2.5V, and 1.2V.Power supplied by a power connector or USB.DC Input Jack. Input Voltage (recommended): 6.5-10V

USB

Two channel USB connection for JTAG and serial communications implemented with FT2232D.EEPROM memory to store configuration settings for FT2232 USB chip.

Spartan 3E FPGA

32MHz oscillator that can be used by Xilinx's DCM to generate any required clock speed.VTQFP-100 footprint that supports Xilinx XC3S100E, XC3S250E, and XC3S500Eparts.I/O can be set to support 1.2V, 2.5V, or 3.3V.

SPI Flash

4M SPI Flash

Wings

48 bidirectional I/O lines which can be split up as: 1x 32 Bit Wing or3x 16 Bit Wings or6x 8 Bit Wings.1" spacing for compatibility with bread boards.

Dimensions

2.7"x2.7"

http://papilio.cc/index.php?n=Papilio.PapilioPro

The Papilio Pro is an Open Source FPGA development board based on the Xilinx Spartan 6 LX FPGA. It has 48 I/O lines, dual channel USB, integrated JTAG programmer, 64Mb SDRAM, and an efficient switching power supply.

Spartan 6 LX9 FPGA (Datasheet)High efficiency LTC3419 Step Down Dual Voltage Regulator (Datasheet)Dual Channel FTDI FT2232 USB 2.0 Full Speed Interface (Datasheet)64Mbit Micron MT48LC4M16 SDRAM (Datasheet)64Mbit Macronix MX25L6445 SPI Flash (Datasheet)48 I/O pins arranged in a Papilio Wing form factor32Mhz Crystal Oscillator

The Papilio Pro includes a 64Mbit Micron MT48LC4M16SDRAM chip. This additional SDRAM will open up a whole new breed of FPGA applications for the Papilio. The timing requirements and refresh signals of the SDRAM chip do make interfacing it more of a challenge than interfacing regular SRAM, or the internal BRAM. We are working on a SDRAM controller that you can drop into your designs so the SDRAM can be used like regular SRAM.

 

SDRAM Designs

Hamster's SDRAM ControllerAlvie's ZPUino SDRAM controller. (derived from Hamster's SDRAM controller).Wishbone wrapper for Alvie's SDRAM controller.XAPP 394 Interfacing Mobile SDRAM with CPLD's.

 

转载于:https://www.cnblogs.com/shangdawei/p/3251671.html

相关资源：蝶翅结构三维石墨相氮化碳光催化材料的制备及其气相异丙醇光降解特性研究