Key Features
High-performance FPGA configuration and PROM/CPLD programming
Includes innovative FPGA-based acceleration firmware encapsulated in a small form factor pod attached to the cableSupports JTAG and Slave-Serial programming topologiesFirmware downloadable over cableEasy to use
Fully integrated and optimized for use with Xilinx iMPACT softwareIntuitive multiple cable management from a single applicationCompatible with Windows and Linux operating systemsAutomatically senses and adapts to target I/O voltageInterfaces to devices operating at 5V (TTL), 3.3V (LVCMOS), 2.5V, 1.8V and 1.5VBus-powered USB device (no power supply required)Flyleads compatibleTarget power status LEDFirmware updates are transparent to the userReliable
Backwards compatibility with Platform Cable USB, including Pb-Free (RoHS-compliant)USB Integrators Forum (USB-IF) certifiedCE and FCC compliantLeverages industry standards, including JTAG Boundary-Scan IEEE 1149.1, SPI and USB 2.0Compatible with Full-Speed and Hi-Speed USB portsPrograms and configures all Xilinx devices**Third-party PROM device programming support
Directly programs selected Serial Peripheral Interface (SPI) flash memory devicesIndirectly programs selected SPI or parallel flash memory devices via FPGA JTAG portHighly optimized for use with Xilinx design tools - ISE® Foundation™ Software, Embedded Development Kit, ChipScope Pro Analyzer and System Generator for DSP.Pb-Free (RoHS-compliant)Recommended for prototyping use only
** Note: Xilinx iMPACT software is required for programming and configuration
Platform Cable USB 功能概述
采用CY7C68013A+XC2C256方案，与原装Platform Cable USB完全兼容支持所有Xilinx器件下载，包括FPGA / CPLD / ISP Configuration PROM所有器件支持JTAG / Slave Serial / SPI下载模式，可配置所有Xilinx器件支持目标系统的下载接口电压：5V / 3.3V / 2.5V / 1.8V / 1.5V支持Xilinx ISE / iMPACT / ChipScope目标器件下载时钟可选，且支持XILINX软件的自动调速
支持的软件
Xilinx ISEiMPACTChipScope
支持的器件
支持所有Xilinx器件下载，包括FPGA / CPLD / ISP Configuration PROM所有器件
产品特性
采用CY7C68013A+XC2C256方案，与原装Platform Cable USB完全兼容
与PC机的连接
通过USB接口与计算机连接
与目标板的连接
通过 JTAG、Slave Serial、SPI 接口与目标板连接
硬件开发环境
通过Platform Cable USB连接“FPGA/CPLD目标板”和“PC”，建立完整的硬件开发环境，对目标芯片进行编程、调试
连接目标板
Platform Cable USB可以通过三种接口连接至目标板，接口定义如下:
Platform Cable USB状态灯说明
红紫色：接入了USB紫色：接入了USB，且Vref有电供入（连接的开发板有上电）
转载于:https://www.cnblogs.com/shangdawei/p/3210344.html
相关资源：Platform Cable USB
